Streamlined Plumbing Field Guide · how to

Plumber or Handyman: What Alabama's Licence Line Actually Turns On

Almost everyone thinks there is a dollar figure below which a plumbing licence stops mattering. Alabama does have those thresholds — but they belong to two other boards, not to this one.

By Brandon ByrdOwner · Licensed Master Plumber
November 20, 2026 · 8 min read
Hands using an adjustable wrench on a chrome trap under a kitchen sink

Nearly everyone who asks this question is looking for a number. Somewhere in the back of most people's heads is the idea that plumbing licensing kicks in above some dollar figure and that below it a competent handyman is fine. It is a reasonable thing to believe, because Alabama really does have those thresholds — they just belong to two other boards.

The distinction matters more than it sounds like it should, because the number people are half-remembering is attached to a rule about the size of a job, and the plumbing board's rule is about the nature of one. Those two tests can give opposite answers on the same afternoon's work. A four-figure kitchen refit might sit outside one board's reach entirely and still be squarely inside the other's. Getting that backwards is how a homeowner ends up believing a small job is exempt when nothing about it was.

Where the number in your head came from

Two Alabama licensing bodies do set their requirements in dollars, and they are the ones most people have half-heard about.

The Alabama Licensing Board for General Contractors defines a general contractor, in the statutory language published on the board's own law page, as one who undertakes construction or superintending of a project "where the cost of the undertaking including labor and materials is $100,000 or more." That is Alabama Code Title 34, Chapter 8.

The Home Builders Licensure Board works the same way at a much lower figure: a residential home builder is one who engages in the construction, remodelling, repair, improvement or reimprovement of a residential structure "where the cost of the undertaking including labor and materials exceeds $10,000." That board's exemptions page even carries a subcontractor rule expressed in dollars — subcontractors hired by a homeowner claiming the homeowner exemption must be licensed if the portion they are hired to do exceeds $10,000.

Both real, both published, both about the size of a job. Neither is the plumbing board.

What does the plumbing board actually say?

The Alabama Plumbers and Gas Fitters Examining Board frames its requirement as an activity, not a price. Its published guidance answers the question of who must be certified with a description of conduct: any person or entity who contracts, engages in, offers to engage in, or conveys the impression that he or she is certified in plumbing.

Read that last clause twice. It is not about the value of the work. It is about holding yourself out as a plumber at all.

The one exemption the board publishes alongside it is equally specific, and it is not a general-purpose loophole: plumbing work — not gas — performed in or about a building owned or occupied by the owner. That is written around the owner. It describes you working on your own house. It does not, on its face, describe somebody you paid to come and do it for you.

Where our own line sits

Everything above is the state's language. What follows is ours, and we would rather be plain about which is which.

The genuinely handyman-appropriate end of plumbing is the accessible, no-tools-into-the-pipe end: replacing a flapper or a fill valve in a toilet tank, swapping a shower head, cleaning an aerator, changing a toilet seat, plunging, replacing a braided supply hose or a plastic basin trap. Those are parts changes on things designed to be changed, and where the DIY boundary sits on a shower head or tub faucet walks through the version of that job that looks simple and is not.

The line moves the moment the work goes into the system rather than onto the end of it. Cutting or joining supply pipe. Opening drain-waste-vent piping. Anything behind a wall, under a slab or above a ceiling. A water heater. Re-routing anything. A new fixture where no fixture was. And anything that carries a permit and an inspection, because a permit is a record with your address on it and it wants a licensed name against it.

That is not a rule about difficulty. Some of the work on the wrong side of that line is easy. It is a rule about who is answerable for it afterwards.

Why it matters after the job is finished

Three consequences, in the order they usually arrive.

Insurance. A water loss gets investigated, and the investigation asks who did the work and whether it was permitted. Informal work on the supply system gives an insurer a legitimate question to ask before it pays, and the sums on a failed supply line are not small — a hidden water leak that ran for a week is a different claim from a burst pipe somebody noticed immediately.

Worth being clear about what a permit actually is, because it is widely treated as a tax. It is a record. Somebody with authority to say so wrote down that a specific alteration was made at a specific address, and then somebody else came and looked at it. That record is what an inspector reads years later, what an insurer's adjuster asks for after a loss, and what a buyer's agent uses to argue the price down. Work that is genuinely fine but has no record behind it is indistinguishable, at that distance, from work that was not.

Resale. Permits attach to the address, not to the owner. An inspector who finds work that plainly needed one and does not have one creates a negotiation at closing that nobody budgeted for. The same goes for materials with a history — identifying polybutylene pipe and what insurers do about it is the version of this problem that predates you entirely.

Recourse. We put a two-year warranty on repair work. That is possible because there is a licensed party standing behind it and a board that person answers to. Informal work has neither, and the practical meaning of that only becomes visible on the day something goes wrong.

How to check a licence in about ninety seconds

The board runs a public lookup, and it is worth knowing how to read it.

  1. Ask for the name on the certificate, not just a number
    Certifications are issued to individuals and to businesses, and the board runs a separate search for each. A number on its own is a claim; a number plus the name it belongs to is something you can check.
  2. Open the board's Individual Lookup
    It lives at alpgfb.igovsolution.net and is linked from the Consumers section of pgfb.alabama.gov as the Licensed Plumber / Gas Fitter Search. There is a Business Lookup tab alongside it for company certifications.
  3. Search by name or number, and narrow by county if you need to
    The form takes a license number, a last name and first name, and a county — Baldwin is on the list. It also filters by license type: apprentice, journeyman plumber, journeyman gas fitter, master plumber, master gas fitter, the combined plumber gas fitter types, and medical gas.
  4. Read the status field, which is the whole point
    The search filters license status three ways: active, lapsed and inactive. Lapsed is the one that catches people out, because the number is real and was once perfectly good. Current is what you are actually checking for.
  5. Match the type to the work
    Plumbing and gas fitting are separate certifications from the same board. Somebody certified for one is not thereby certified for the other, which is why we say plainly that we hold the plumbing certification and do not do gas work.

The practical version

If the job is a part that unscrews, it is a part that unscrews. If the job goes into the pipe, into a wall, under a slab, or onto a water heater, it wants a licensed plumber — and in Alabama that is determined by what the work is, not by what it costs.

For the small end, faucet and fixture repair and toilet repair and replacement are ordinary same-visit jobs. For the large end, whole-home repipe work carries permits and inspections as a matter of course, and the whole-home repipe cost guide explains what actually drives the range. Around Fairhope, Daphne and up through Robertsdale and Bay Minette, the housing stock is old enough that a fair number of "small" jobs turn out to be attached to something older than the fixture.

Ask whoever you call which of those two categories your job is in, and ask them to say why. A tradesman who cannot draw the line for you probably is not thinking about it.

(251) 423-7654, any hour. Brandon Byrd, Alabama Master Plumber MP-4462.


Sources. Requirement stated as activity — "Any Person or Entity who contracts, engages in, offers to engage in, or conveys the impression that he or she is certified in plumbing" — and the owner-occupied exemption, "Plumbing work (Not Gas) performed in or about a building owned, or occupied by the owner": Alabama Plumbers and Gas Fitters Examining Board, licensee Frequently Asked Questions (pgfb.alabama.gov/licensees/frequently-asked-questions/). Certification types and definitions of apprentice, journeyman and master, plumber and gas fitter: the board's "How Do I Become Licensed?" page. Consumer guidance to "Check to see if the contractor holds the required licenses": the board's hiring-a-contractor page. Lookup fields, license types and the active / lapsed / inactive status filter: the board's Individual Lookup (alpgfb.igovsolution.net/online/Lookups/Individual.aspx), linked from pgfb.alabama.gov/consumers/. Board office number (205) 945-4857 as published on that lookup. General contractor threshold of $100,000 and the statutory definition: Alabama Licensing Board for General Contractors, Law page (genconbd.alabama.gov/about/law/), citing Alabama Code Title 34, Chapter 8. Residential home builder definition, the $10,000 figure and the homeowner-exemption subcontractor rule: Home Builders Licensure Board (hblb.alabama.gov), applicant FAQs and Exemptions pages. All retrieved 2026-08-04. No dollar threshold for plumbing certification was located in the plumbing board's published material; that is an absence of evidence, not a board ruling.

ShareXFacebook

Questions. Answered.

  • Is there a dollar amount under which I do not need a licensed plumber in Alabama?
    Not one the Plumbers and Gas Fitters Examining Board publishes. Its own guidance answers the question in terms of activity — anyone who contracts, engages in, offers to engage in, or conveys the impression that they are certified in plumbing needs the certification — and the only exemption it lists is the owner working on a building they own or occupy. Alabama does have dollar thresholds, but they belong to the general contractor board and the home builders board, which are separate bodies with separate rules. If you want that confirmed in writing for a specific job, the plumbing board takes calls at (205) 945-4857.
  • So what can a handyman legitimately do?
    Plenty, and useful things. Replacing a toilet flapper or fill valve, swapping a shower head, cleaning or changing a tap aerator, changing a toilet seat, plunging a blockage, replacing a flexible supply hose or a plastic trap under a basin — those are homeowner-level parts changes on the accessible end of a fixture. Our own working line is simple: if the job means cutting or joining into the building's supply or drain-waste-vent piping, or working behind a wall, under a slab or on a water heater, that is a plumber's job regardless of what the invoice comes to.
  • Why does it matter for insurance?
    Because a water claim is investigated, and the investigation asks who did the work. Unpermitted or unlicensed alterations to the plumbing system give an insurer a legitimate question to ask before it pays, and the loss on a failed supply line is rarely small. This is also the reason we would rather be told up front that a previous repair was informal — knowing what was done, and by whom, changes what we look at first and it is not a judgement about anybody.
  • Does it matter when I sell the house?
    It can. Alabama residential sales run on disclosure and on inspection, and an inspector who finds work that plainly required a permit and does not have one creates a negotiation you did not plan for. Permit and inspection records also live with the address rather than with you. The practical upshot is that the cheap version of a repair is sometimes the expensive version deferred by a few years, paid at closing instead of at the time.
  • How do I verify a plumbing licence in Alabama?
    The board runs a public Individual Lookup and a Business Lookup. You can search by license number, by last and first name, or by county, and you can filter by license type — master plumber, journeyman plumber, master gas fitter and so on — and by license status, which offers active, lapsed and inactive. Read the status. A number quoted on a truck or a business card only tells you a number exists; the board's record is what establishes that the certification behind it is current and in the name you were given.
Related resources

Keep going.

Pages on the site that connect to this article — the plumbing work it covers, the towns it applies to, and the natural next step if you're ready to get someone out.

Free tools that pair with this guide

  • Plumbing Symptom Checker

    Pick what the house is doing and get the likely cause, how urgent it is, and the check you can make yourself. Free, no email.

  • Water-Waste Calculator

    Turns a drip or a running toilet into gallons and dollars a year, using EPA WaterSense math.

Get help

Need a Service Call?

Reading the article and recognizing the problem? Skip ahead — call us.

Call nowSchedule service